Water Heater Repair in San Angelo, TX
No hot water, lukewarm water, or a leaking tank — diagnosed and repaired on gas and electric residential water heaters.
Losing hot water is one of the least convenient appliance failures a household deals with, and it’s usually caused by one of a small number of well-understood parts: a heating element, a thermostat, a pilot/igniter assembly, or — on older tanks — sediment buildup from San Angelo’s hard water. We diagnose which one it is before recommending any repair or replacement.
Common Water Heater Repair Problems We Diagnose
| Symptom | Likely cause |
|---|---|
| No hot water at all (electric) | Usually a failed upper heating element or a tripped high-limit reset switch. |
| No hot water at all (gas) | Typically a pilot light that won’t stay lit, a failing thermocouple, or a gas control valve fault. |
| Water is hot but runs out quickly | Often sediment buildup reducing tank capacity, or a failing lower heating element on electric units. |
| Water heater leaking from the tank or fittings | Can be a loose fitting or valve (repairable) or a corroded tank (typically requires replacement, not repair). |
| Water temperature inconsistent or fluctuating | Usually a failing thermostat or sediment interfering with the heating element’s contact with water. |
Signs You May Need Water Heater Repair
- Water takes noticeably longer to heat up than it used to
- Rumbling or popping sounds from the tank (a sign of sediment buildup)
- Water pooling at the base of the unit
- The pilot light won’t stay lit on a gas unit
- Rust-colored water from the hot tap only
What Affects the Cost of Water Heater Repair
| Factor | Why it matters |
|---|---|
| Repair vs. replacement | Element, thermostat, and thermocouple repairs are cost-effective; a corroded tank generally isn’t repairable |
| Gas vs. electric | Gas units involve venting and combustion components; electric units involve elements and thermostats |
| Tank age | Units past 10–12 years old are more likely to need replacement than repair |
| Sediment flushing | A maintenance flush can resolve capacity and noise issues without a part replacement |
Every visit includes an upfront diagnostic, so you’ll know the exact cost before any repair begins — not an estimate that changes once the technician is on-site.
Related Services
Water Heater Repair Questions We Hear Most
Can a leaking water heater be repaired, or does it need replacing?
It depends on where the leak is. A loose fitting, valve, or drain cock can be repaired. A leak from the tank body itself means the tank has corroded internally and needs to be replaced — repair isn’t possible at that point.
Why does my water heater make popping or rumbling noises?
This is almost always sediment that has settled at the bottom of the tank, and it’s especially common with San Angelo’s water hardness. Water and steam get trapped under the sediment layer and pop through it, which is what causes the noise. A professional flush usually resolves it.
Do you work on both gas and electric water heaters?
Yes, we diagnose and repair both gas and electric residential tank water heaters.
Need Water Heater Repair in San Angelo?
Call (325) 610-0443 or request service online — most repairs are scheduled same-day.